Industrial Gauges

Specialize in all aspects of harsh environment electronics manufacturing.

2″ – Transmission Temperature Gauge

2″ – Transmission Temperature Gauge

A temperature gauge operates by sending a low amperage current through the gauges’s meter to ground via a sending unit with variable resistance. The resistance of the sending units increase or decrease

2″ – Multifunction Snap-In Gauges

2″ – Multifunction Snap-In Gauges

Designed to SAE specifications for Dust, Vibration and Water intrusion, the snap-in instruments are easy to install with a push-in case manufactured in the USA. No back clamp, washers, nuts or tools

2″ Variable Frequency Tachometer

2″ Variable Frequency Tachometer

This 2-inch Tachometer connects to the Alternator signal. The tachometer has four range selections for rough calibration and an adjustment potentiometer for fine adjustment. The use of DIP switches on the back

Digital Hourmeter with Voltage Trigger

Digital Hourmeter with Voltage Trigger

The Digital Hourmeter starts recording Engine Running Only hours when the voltage is measured above 12.8 VDC. Riverside snap-in instruments are heavy duty and easy to install with a push-in case, manufactured

J1939 – CAN Display with alert LEDs

J1939 – CAN Display with alert LEDs

The NexSysLink CAN Bus display instrument reads and processes SAE J1939 compliant CAN messages. The sunlight visible, transflective LCD displays operating parameters and is complemented by three discrete alert LEDs. An intuitive

J1939 – DEF Level Instrument

J1939 – DEF Level Instrument

This NexSysLink® stand-alone instrument directly interfaces to an SAE J1939 compliant CAN bus without the need for a Master Node Instrument or some other gateway device to display DEF (Diesel Exhaust Fluid)

J1939 – Digital Hourmeter

J1939 – Digital Hourmeter

Designed to SAE specifications—Riverside snap-in instruments are heavy duty and easy to install with a push-in case manufactured in the USA. No back clamp, washers, nuts or tools are required to install

J1939 – DPF Display – Tier 4

J1939 – DPF Display – Tier 4

The NexSysLink® CAN Bus display instrument reads and processes SAE J1939 compliant CAN messages then displays the CAN message parameter values on a two-line dot-matrix LCD. The instrument’s small footprint, LCD information

J1939 – Engine Control Kit

J1939 – Engine Control Kit

These digital gateway systems, available in the Speedometer or Tachometer, are a feature-rich, intuitive engine monitoring solution for the instrument market. The digital instrumentation communicates directly with the J1939, NMEA2000 and SmartCraft

J1939 – MG1000

J1939 – MG1000

The MG1000 is the stepping stone of digital instrumentation. This innovative digital gauge system requires no LCD’s, no system initialization, no menu setups and no user manual interaction for use—ever! Just install

J1939 – MG3000

J1939 – MG3000

Designed to SAE specifications for Dust, Vibration and Water intrusion, the snap-in instruments are easy to install with a push-in case manufactured in the USA. No back clamp, washers, nuts or tools

J1939 – NexSysLink

J1939 – NexSysLink

NexSysLink®, as its name implies, is the next generation instrumentation system from Faria Beede that connects you with critical operating data transmitted by CAN (Controller Area Network) based apparatus.